logo Astel electronics and industrial automation
   italiano IT     inglese EN    
Google
 Company  |  Wafer Handling  |  Electronic design  |  Healthcare  |  Security  | |  Products  |
[Products] > [Indexer] > [ISC]

Stepper drivers
Stepper motors
Oscillators
Indexer
Microstepper modules
Full system
DC drivers
Linear axes
Controllers

Sport & Racing

Home & Building

INDH
INDW
ISC
 ISC (Intelligent Stepper Controller)

The ISC board is a complete and intelligent stepper motor controller. It can operate either in the stand-alone mode or connected with a standard serial interface.

The device communicates by simple mnemonic commands sent by standard RS-232 or RS-422-485 serial line.

A 2KBytes E2PROM memory contains user programs and operating parameters.

MAIN FEATURES

  • Low cost, fuly programmable stepper controller board
  • PC controlled or stand alone operations
  • Interfacciamento tramite standard RS232 standard (ISC-01) o RS422/485 (ISC-02) con velocità compresa tra 300 e 38,400bps
  • Alimentazione, non stabilizzata compresa tra 10 e 35Vdc/ac
  • Completo linguaggio di programmazione con più di 30 comandi mnemonici con ricerca della posizione zero
  • Standard “Eurocard” for 19” rack mounting
  • 5 user defined I/O for simple automations without need for an additional PLC
  • Multi axis operations over the same serial line
  • Optionals:
    - mother-board
    - control SW


      

 TECHNICAL CHARACTERISTICS
  • Absolute or relative positioning commands with 24 bit resolution
    (up to 16,777,215 steps for movement)
  • Full, half and quarter step mode operations
  • Programmable acceleration and deceleration ramp programmable “on the fly”
  • Bi-directional ramping between speeds and alterable during movements
  • Speed up to 23,000 steps for seconds (more then 6,000 rpm with standard 1.8° stepper motor)
  • Programmable holding and slewing currents (with STP170 and STP250 driver boards)
  • Full status control through a remote terminal
  • Programmable polarity of limit and home inputs
  • 2KByte non volatile memory for user programs
  • All I/O are optocoupled, polarity programmable and with optional built-in pull-ups allowing a spread voltage range
  • Jogging capabilties with a joystick for manual positioning
  • Motion output for syncronization and dedicated inuts for emergency stop and auto cycle.
  • Programmable trip point output for external syncronization
  • Automatic subroutine execution on trip point
  • Vector on port operations capabilities
OTHER RELATED PRODUCTS



DOWNLOAD


Example

Manual

Brochure

 Support  |  Enquiry form  |

Home |  Contact us |  Notices | Links | Site map | 

Astel electronics and industrial automation ®   

Copyright © 2006 Astel - Tutti i diritti riservati - P.IVA 07083610019