logo Astel electronics and industrial automation
   italiano IT     inglese EN    
Google
 Company  |  Wafer Handling  |  Electronic design  |  Healthcare  |  Security  | |  Products  |
[Products] > [Stepper drivers] > [STP170]

Stepper drivers
Stepper motors
Oscillators
Indexer
Microstepper modules
Full system
DC drivers
Linear axes
Controllers

Sport & Racing

Home & Building

PicoSTP
STP170
STP250
STP300D
STP300M
STP600D
STP900D
STP650
STP1000
 STP170

The STP-170 module is suitable for high-performance and low-cost bipolar motor stepper driving. This driver can operate from 12 to 42Vdc with a nominal current of 1.7A A wide series of accessories are also avalaible to complete and customize the application.

APPLICATIONS

  • Positioning systems
  • Automatic machinery
  • Servosystems
  • Robots
  • Axes control

GENERAL SPECIFICATION

  • Low cost, stepper driver board
  • Full and half step operations
  • 3 current levels externally selectable
  • High frequency PWM bipolar chopper design
  • Standard Eurocard for 19” rack mounting
  • Overvoltages, overtemperature and short-circuits protected
  • Optional: oscillator with ramps (VCOL), transformer, power supply, mother board, controller (ISC).





 TECHNICAL CHARACTERISTICS
Supply voltage
Power stage: min. 12Vdc max 40Vdc.
Logic: 12Vcc +5%.

Phase current
Settable continuosly by means of a potentiometer.
Externally selectable at 30%, 60% and 100% of the nominal current.
Up to 1.7 A/phase.

Resolution
HALF or FULL step selectable by means of an external signal.

Motor types
For stepper motor with 4,6 or 8 windings in serial or parallel mode.

Oscillator
Optional module, to generate step pulses with acceleration and deceleration ramps.

Inputs
All inputs are compatible with standard TTL or CMOS.

DIRECTION input
When this input is activated, the motor direction is reversed.

STEP input
Minimum pulse width: 10us
Maximum frequency: 50KHz.

ENABLE input
Optically insulated direction input.
This input enables the driver output stage and, when disabled, the motor is deenergized.

RESET input
When activated, this input reset the motor windings to the default state.

OTHER RELATED PRODUCTS

    (ISC) Intelligent controller
    (VCOL) Oscillator with ramps

DOWNLOAD


Example

Manual

Brochure

 Support  |  Enquiry form  |

Home |  Contact us |  Notices | Links | Site map | 

Astel electronics and industrial automation ®   

Copyright © 2006 Astel - Tutti i diritti riservati - P.IVA 07083610019